I work left to right. I'm sure it's a function of all the mentors and labs I've worked in because I've never even thought about doing it the other way. I've never been in or built a darkroom that went right to left. Good question for the group. Bob Younger -----Original Message----- From: pure-silver-bounce@xxxxxxxxxxxxx [mailto:pure-silver-bounce@xxxxxxxxxxxxx] On Behalf Of Kurt J. Griffin Sent: Monday, April 06, 2009 5:28 PM To: pure-silver@xxxxxxxxxxxxx Subject: [pure-silver] Re: Process direction >For the fun of it Tim, I noticed you go left to right! For some reason >I do all my processing right to left. >It doesn't matter on bit, but I can't remember a darkroom I've been in >that's not right to left. I suppose it all depends where the sink is. > >How about the rest of you? > >E. > I'm used to going Left to Right. My current setup has my enlarger just past the end of my sink, so for the first time I'm going right to left so the developer is closest to the enlarger. --KJG ============================================================================ ================================= To unsubscribe from this list, go to www.freelists.org and logon to your account (the same e-mail address and password you set-up when you subscribed,) and unsubscribe from there. ============================================================================================================= To unsubscribe from this list, go to www.freelists.org and logon to your account (the same e-mail address and password you set-up when you subscribed,) and unsubscribe from there.