Found this information doing a search on Google..... Discharging CMOS RAM will cause the hard drive type information and all other SETUP data to be lost. If the hard drive type information is not set back to the same values, data may not be able to be recovered from the drive. The BIOS code on a PC resides in one or more ROM chips, usually socketted 256KB EPROM chips. Look in your motherboard/PC's manual for a jumper that will reset the CMOS. If you can't find it in the manual, look on your motherboard and find the battery. There should be a jumper with three (3) pins directly adjacent to the battery. To reset the CMOS Settings/Password, move the jumper to the 2-3 position if it is currently 1-2, or 1-2 if it is currently 2-3, then turn on the system, wait a few seconds, then turn the power off. Now, move the jumper back to the original pins. Password disabled Haven't tried it, but it seems to give specific instructions for doing as Darryl suggested. Tori Darryl wrote: > Or putting a jumper across the 2 pins that clear the CMOS > > Darryl > > ----- Original Message ----- > From: "~OoO~" > > > Try taking the battery out for longer than just a few minutes... try a few > hours. > > To unsub or change your email settings: > //www.freelists.org/webpage/pctechtalk > > To access our Archives: > http://groups.yahoo.com/group/PCTechTalk/messages/ > //www.freelists.org/archives/pctechtalk/ To unsub or change your email settings: //www.freelists.org/webpage/pctechtalk To access our Archives: http://groups.yahoo.com/group/PCTechTalk/messages/ //www.freelists.org/archives/pctechtalk/