[modeleng] Re: Granite Surface Plate
- From: "Barrie Purslow" <bpduo@xxxxxxxxxxxxx>
- To: <modeleng@xxxxxxxxxxxxx>
- Date: Sun, 14 Oct 2012 11:25:33 +0100
Hello Roger,
I recently made a workbech out of a similar material - it is imitation
granite but the surface looks very similar to your proposed work surface.
It's a disaster area - any small component that I place on it just
disappears!
Regards,
Barrie
----- Original Message -----
From: "Roger Mason" <roger.g3tdm@xxxxxxxxxx>
To: "Model Engineering List - Latest" <modeleng@xxxxxxxxxxxxx>
Sent: Saturday, October 13, 2012 4:45 PM
Subject: [modeleng] Granite Surface Plate
> Hi All,
> I wonder if anyone has seen the following granite work surface:
>
> http://www.scottsofstow.co.uk/Granite-Chopping-Board/Product1_22051_-1_264215_10551?categoryId=26198&top_category=26152&parent_category_rn=&urlLangId=-1
>
> I am wondering if it would make a good surface plate in the
> workshop. For twenty quid, plus a fiver for p&p it sounds quite
> attractive!
>
> Does anyone have any experience of this good looking lump of
> granite? Is it flat? Does it scratch too easily?
>
>
> Cheers,
>
> Roger Mason, in St. Agnes.
>
>
> MODEL ENGINEERING DISCUSSION LIST.
>
> To UNSUBSCRIBE from this list, send a blank email to,
> modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject
> line.
>
MODEL ENGINEERING DISCUSSION LIST.
To UNSUBSCRIBE from this list, send a blank email to,
modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.
Other related posts:
