[JA] What does this mean???
- From: Babette C Bloch <bvcb@xxxxxxxx>
- To: juno_accmail@xxxxxxxxxxxxxxxxx
- Date: Sun, 26 Aug 2001 16:33:40 -0700
I found this in the Juno 4 Help files. I understand the part about
installing Dial-Up Networking, but what's the rest for? Is for folks on
a Network?
b
Install Dial-Up Networking and Remote Access Services
You may prefer to wait to install Dial-Up Networking until you've created
your Juno account; if you do so, Juno will be able to do most of the
installation for you. If you decide to go ahead now, you can print out
this topic for reference by clicking the Print button at the top of the
Juno Help window.
To install Dial-Up Networking before you've created an account:
1. You must have your Windowsâ installation disks, or the Windows backup
installation files on your computer.
2. Exit out of Juno setup by clicking Cancel. (Note that the information
you've entered so far will not be retained.)
3. Click on the Windows Start button and select Settings, then Control
Panel.
4. Double-click on Add/Remove Programs.
5. Click on the Windows Setup tab.
6. Double-click on Communications.
7. If there's no checkmark next to Dial-Up Networking, check the box by
clicking inside it.
8. Click OK, and then exit the Add/Remove Programs dialog box by
clicking OK again.
9. If there are no Windows backup files on your computer, you should be
prompted to insert your Windows install disk in your disk drive or CD-ROM
drive. Insert the disk or CD and click OK.
10. When Windows is finished installing Dial-Up Networking, go back to
the Control Panel window.
11. Double-click on Network.
12. On the Configuration tab, you should see listings for Dial-Up Adaptor
and for TCP/IP under the box labeled The following network components are
installed. If you see these listed, you're done and you can go back to
creating your Juno account.
13. If TCP/IP is missing, click Add.
14. Select Protocol and click Add.
15. From the Manufacturers list on the left side of the dialog, select
Microsoft.
16. From the Network Protocols list on the right side of the dialog,
select TCP/IP.
17. Click OK and then exit the Network dialog by clicking OK again.
18. If you didn't leave your Windows disk or CD in its drive, you should
be prompted to insert it again. Do so and click OK.
19. When Windows is finished installing TCP/IP, you will be prompted to
restart your computer. You can click No if you'd like to save work
before restarting your computer, but you must restart your computer
before the changes take affect. Once you do so, you can go back to
creating your Juno account.
To unsubscribe, send a message to listar@xxxxxxxxxxxxxxxxx with
"unsubscribe juno_accmail" in the body or subject.
OR visit http://freelists.dhs.org
~*~
Other related posts:
