Re: SecurNAT outbound access
- From: "Sean Faust" <sfaust@xxxxxxxxxx>
- To: "[ISAserver.org Discussion List]" <isalist@xxxxxxxxxxxxx>
- Date: Tue, 29 Jan 2002 13:28:16 -0500
Is the RRAS wizard for ISA under the Network Configuration Node and if
so which one is it?
Sean Faust
American Red Cross
Atlanta Chapter
Office (404) 575-3123
Cell(404) 909-0778
sfaust@xxxxxxxxxx
-----Original Message-----
From: Jim Harrison [mailto:jim@xxxxxxxxxxxx]
Sent: Tuesday, January 29, 2002 12:54 PM
To: [ISAserver.org Discussion List]
Subject: [isalist] Re: SecurNAT outbound access
http://www.ISAserver.org
If you have ISA installed in Firewall or Integrated mode, you have a NAT
editor installed.
You should see no "NAT" entries in any interface properties with ISA
installed. If you do, disable RRAS and reinstall it using ONLY THE ISA
WIZARDS.
Jim Harrison
MCP(NT4, W2K), A+, Network+, PCG
http://isaserver.org/authors/harrison/
Read the books!
----- Original Message -----
From: "mike" <mbailoux@xxxxxxxxxxxx>
To: "[ISAserver.org Discussion List]" <isalist@xxxxxxxxxxxxx>
Sent: Monday, January 28, 2002 09:29
Subject: [isalist] Re: SecurNAT outbound access
http://www.ISAserver.org
Hey Jim
I checked the nic bindings and they are set as internal - external -
RRAS.
I do not have any extra subnets in the routes, but I do have one
question.
Are there supposedto be NAT entries under the interfaces. As far as I
can
see I do not have any NAT protocols installed, but when I right-click on
an int. in RRAS and check the NAT there is an entry, is this normal, and
if not how do I get rid of it.
Thanks
Mike
------------------------------------------------------
You are currently subscribed to this ISAserver.org Discussion List as:
jim@xxxxxxxxxxxx
To unsubscribe send a blank email to $subst('Email.Unsub')
------------------------------------------------------
You are currently subscribed to this ISAserver.org Discussion List as:
sfaust@xxxxxxxxxx
To unsubscribe send a blank email to $subst('Email.Unsub')
Other related posts:
