Austin, Sometimes I find if you ix 0 the shape it forces it to update. Gerry Meier, Sr. PCB Designer Freedom CAD Services. Inc Voice: (256)776-7470 or (603) 864-1350 Email:gerry.meier@xxxxxxxxxxxxxx visit us at http://www.freedomcad.com Austin, Sometimes I just ix 0 Gerry Meier, Sr. PCB Designer Freedom CAD Services. Inc Voice: (256)776-7470 or (603) 864-1350 Email:gerry.meier@xxxxxxxxxxxxxx visit us at http://www.freedomcad.com ________________________________ From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Austin Franklin Sent: Friday, August 15, 2008 8:55 AM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] dynamic shapes (planes) not showing holes correctly? Hi, My planes, which are dynamic shapes, aren't showing all the holes as shown in this picture: The big hole is shown as I'd expect, but the smaller ones (which are on a different net) are "covered over". But, when I move this component off the board, then back on, the holes come through correctly. How can I regenerate these shapes to show the holes as expected, without having to move all the components? Regards, Austin