[PCB_FORUM] Windows 7 64 bit and allegro 16.3
- From: "Dharma Kemp-Bresett" <dharma@xxxxxxx>
- To: <icu-pcb-forum@xxxxxxxxxxxxx>
- Date: Thu, 22 Mar 2012 18:47:16 -0400
Hi Everyone,
We are looking to purchase a new computer to run allegro 16.3 on. The new
machines are all windows 7 now.... I did some looking around on various
forums and several people were having problems getting it to work on Win 7
64 bit machines. Most stated they had no problems with 32bit but either had
to run a virtual machine to get it working or couldn't get it to run at all
on 64 bit. I did not find follow up info suggesting if it was no longer an
issue or if they found other good solutions. So in a nutshell my question
is: are people still having these problems or do the newer sr's fix this?
We would obviously prefer 64bit but if it is going to pose any major
problems with setup then it may be best to just go with 32 bit.
Thanks in advance,
Dharma
KAW/USA
Suite 448
20 Trafalgar Square
Nashua, NH 03063
Confidentiality Notice: This email and any accompanying documents contain
information that is confidential, privileged or exempt from disclosure under
applicable law and is intended for the exclusive use of the addressee. This
information is private and protected by law. If you are not the intended
recipient, or have received this email in error, you are hereby notified
that any disclosure, copying, distribution or use of the contents of this
document in any manner is strictly prohibited.
-----------------------------------------------------------
To subscribe/unsubscribe:
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe
To view the archives of this list go to
//www.freelists.org/archives/icu-pcb-forum/
Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------
Other related posts:
