Hi Gary, Go to the color menu and select the display option. Make sure in the upper right shadow mode is on, then use the slide bar below it to control how "dim" things are. It ranges from not very dim at all, to pretty much gone, the latter should satisfy his needs. From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Macindoe, Gary Sent: Wednesday, July 09, 2008 4:37 PM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Shadow mode adjustable? Hey guys, Not sure if you will get this, I haven't seen an e-mail from the Forum for some time now (everyone on vacation?). An engineer wants to highlight a net (routed on several different trace layers), and then see only the highlighted traces. Well, as far as I know, the only way to even get close to this is to highlight the net, then use Shadow Toggle. This "dims" the non-highlighted traces, but they're still there. Does anyone know of a way to adjust the "dimming" effect of Shadow Toggle? Thanks for any responses! Gary Gary E. MacIndoe PCB Design Engineer Fort Collins, Colorado amd.com gary.macindoe@xxxxxxx