Thanks Jean-Charles, I had forgotten it was there! Gary E. MacIndoe PCB Design Engineer Fort Collins, Colorado amd.com gary.macindoe@xxxxxxx -----Original Message----- From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Jean-Charles TEYSSIER Sent: Wednesday, July 09, 2008 2:38 PM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Re: Shadow mode adjustable? 15.7: Diplay->Colr/Visiblity then select "Display" in group (top-left) and adjust the shadow mode. Jean-Charles Macindoe, Gary a écrit : > > Hey guys, > > Not sure if you will get this, I haven't seen an e-mail from the Forum > for some time now (everyone on vacation?). > > An engineer wants to highlight a net (routed on several different > trace layers), and then see only the highlighted traces. > > Well, as far as I know, the only way to even get close to this is to > highlight the net, then use Shadow Toggle. > > This "dims" the non-highlighted traces, but they're still there. > > Does anyone know of a way to adjust the "dimming" effect of Shadow Toggle? > > Thanks for any responses! > > Gary > > *Gary E. MacIndoe > *PCB Design Engineer > Fort Collins, Colorado > > amd.com > > gary.macindoe@xxxxxxx > ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx ----------------------------------------------------------- ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx -----------------------------------------------------------