[PCB_FORUM] Schematic Symbol (Part) Question
- From: "Vince Di Lello" <vince.dilello@xxxxxxxxxxxxxxxx>
- To: <icu-pcb-forum@xxxxxxxxxxxxx>
- Date: Fri, 5 Jan 2007 11:52:00 -0800
Good afternoon fellow designers,
Folks I have a couple schematic symbol (or Part as Cadence calls them)
questions:
1: Below is a screen shot of a symbol I am in the process of creating.
See how the pin signal name appears both inside and outside the outline
- is there any way to see the Pin Number on the outside of the outline
instead of the signal name? I would prefer to see the symbol in the
editor as it will look in the schematic.
2: Below is a screen shot of the same symbol inserted into a schematic
page. The pin numbers are now visible (as I would have wanted to the
symbol to be), but the problem I am having now is that the Pin Number
text size is too large and overlapping each other. Would you happen to
know how to reduce the text size of the Pin Numbers.
Thanks in advance to all for your appreciative help.
Vincent Di Lello, CID+
Senior PCB Designer
Kaleidescape Canada, Inc.
vdilello@xxxxxxxxxxxxxxxx
1 519 772 6418 (direct)
1 519 772 6401 (fax)
www.kaleidescape.com
Other related posts:
