[PCB_FORUM] Concept signame question

Hello,
Is there a way to tell if signames are attached to a wire instead of a flag? Besides attributing each wire which is very time consuming.
We found that a signame can be accidentally assigned to a flag pin instead of a wire segment.
Therefore, the connection is not made in the board.

How can we verify this was not done in our schematics.

Thanks,
Mark


_____________________________________________________________________________
Scanned by IBM Email Security Management Services powered by MessageLabs. For more information please visit http://www.ers.ibm.com
_____________________________________________________________________________
-----------------------------------------------------------
To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to 
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts: