[PCB_FORUM] Re: Concept signame question

Have you tried using the show attachment? If a signal name is attached
to a pin there should
be a red line to the pin. Signal names attached to wires show where the
name is attached on the wire.

Shirley in Oregon 

-----Original Message-----
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Mark Salberg
Sent: Thursday, September 07, 2006 6:45 AM
To: Cadence User Group
Subject: [PCB_FORUM] Concept signame question

Hello,
Is there a way to tell if signames are attached to a wire instead of a 
flag? Besides attributing each wire which is very time consuming.
We found that a signame can be accidentally assigned to a flag pin 
instead of a wire segment.
Therefore, the connection is not made in the board.

How can we verify this was not done in our schematics.

Thanks,
Mark


________________________________________________________________________
_____
Scanned by IBM Email Security Management Services powered by
MessageLabs. For more information please visit http://www.ers.ibm.com
________________________________________________________________________
_____
-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------
-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to 
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts: