Hello all Did Enabling Tec. Build the Versapoint for Freedom Scientific? If so, maybe you can get support from them. I've always gotten fabulous support from Enabling. Best regards Gator -----Original Message----- From: duxuser-bounce@xxxxxxxxxxxxx [mailto:duxuser-bounce@xxxxxxxxxxxxx] On Behalf Of Steve Dresser Sent: Friday, December 05, 2003 3:38 PM To: duxuser@xxxxxxxxxxxxx Subject: [duxuser] Re: VersaPoint Duo Question On Friday 12/5/03 14:37 fdaniels wrote: >Does the battery lose its "oomph" over time if the printer is not used? How >long is the life to the battery? It's hard to predict how long the battery will last, but they do die after a while. One of my Juliets lost its mind after about five years, and the cause was a dead battery. I don't think it matters whether or not the embosser is used because the battery has to keep the RAM refreshed whether the embosser is running or not. It's probably a good idea to have the machine checked. Steve * * * * This message is via list duxuser at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting //www.freelists.org. The list archive * is also located there. * Duxbury Systems' web site is http://www.duxburysystems.com * * * * * * * This message is via list duxuser at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting //www.freelists.org. The list archive * is also located there. * Duxbury Systems' web site is http://www.duxburysystems.com * * *