When I press enter to change the volume, I can write the value with numbers and press enter. Then the volume changes. But while trying to arrow around there it jumps to the volume of the next track. And its exactly the same with the panning. I can write 25l manually after I pressed enter, but I can?t go with the arrow keys. It doesn?t matter if I refresh the screen with f6. The screen resolution is right. I followed all instructions about changes in Windows. I also have another problem that maybe could be linked to the other one. If I solo, mute or arm a few tracks and I want to unsolo/unarm all tracks and I press the key 3 times, it doesn?t make anything change. I will only be able to unsolo/unmute/unarm the track where the cursor is. Apart from that, It works just fine to browse around in the track view. Its no problem to add effects and control them for example. Best /Henrik _____ Från: ddots-l-bounce@xxxxxxxxxxxxx [mailto:ddots-l-bounce@xxxxxxxxxxxxx] För Rui Vilarinho Skickat: den 27 augusti 2011 17:30 Till: ddots-l@xxxxxxxxxxxxx Ämne: [ddots-l] Re: volume/panning problem Hi, To change that way: You must do Enter to change values, and Enter, to get out. Dont forget the dash symbol for left pan. and negative minus zero ,volume value. Also, the plus symbol for right pan. together with the numbers. refresh the track pain with the function key. F6. Check if the display is. Custom Cake Talking Tab. with Shift plus arrows right and left. good luck, best regards, Rui Vilarinho ----- Original Message ----- From: Henrik <mailto:gnisslargbg@xxxxxxxxx> Leander To: ddots-l@xxxxxxxxxxxxx Sent: Saturday, August 27, 2011 10:00 AM Subject: [ddots-l] volume/panning problem Hi guys. After reinstalling Sonar, when I come to the usual volume and pan dialogs in the track pane, I can type in a value for the volume or pan and make it change. But as soon as I arrow up or down it goes out of the dialogue and jumps to other tracks. Is this some resolution problem or anything? Or what could it be? Best /Henrik