I'm not sure that an answer was given, therefore this message. In message <481F7105.60904@xxxxxxxxxxxxxxxx> Michael Ben-Gershon <mybg@xxxxxxxxxxxxxxxx> wrote: > Is there any way to set tabs at intervals which do not fall on exact > millimeter boundaries? I have tried entering a value (say, 41.5mm) in > the dialogue box but it gets truncated to 41mm later. Yes, there is. When setting the tab position in Edit style -> Tabs you must hit <Return> before clicking on the <OK> button. If you forget the <Return> the tab position falls back to the full millimeter setting. What precedes is valid for OvPro and OPwin. It is mentioned on page 61 of the OvPro manual. -- Greetings, JohnvV To unsubscribe or subscribe goto: //www.freelists.org/list/davidpilling