[softwarelist] Re: Tab settings granularity

In message <481F7105.60904@xxxxxxxxxxxxxxxx>, Michael Ben-Gershon <mybg@xxxxxxxxxxxxxxxx> writes
Is there any way to set tabs at intervals which do not fall on exact millimeter boundaries? I have tried entering a value (say, 41.5mm) in the dialogue box but it gets truncated to 41mm later.
Hmm. that is probably a bug, at some point, someone had the bright idea that tabs should snap to mm boundaries.
I think you can set tabs where you want e.g. 49.5 mm, the tab stops there until you select it, when the dialogue snaps it to the nearest mm. 

So you can set them via the dialogue or DDL.


--
David Pilling
email: david@xxxxxxxxxxxxxxxxxxx
  web: http://www.davidpilling.net
 post: David Pilling P.O. Box 22 Thornton Cleveleys Blackpool. FY5 1LR UK
  fax: +44(0)870-0520-941


To unsubscribe or subscribe goto: http://www.freelists.org/list/davidpilling

Other related posts: