[blindwoodworker] Re: Tough drilling
- From: George Wurtzel <gmwurtzel@xxxxxxxxx>
- To: "blindwoodworker@xxxxxxxxxxxxx" <blindwoodworker@xxxxxxxxxxxxx>
- Date: Wed, 24 Oct 2012 06:14:02 -0500
hi John,
I do not no if you have access
to a lathe with a 4 jaw chuck
if so put peace
in chuck with flat side facing tale peace and put drill in tale and the
lathe will drill ded center of your peace
eCordially,
George M. Wurtzel
www.gmwurtzel.com
"Success is not final, failure is not fatal: it is the courage to continue that
counts."
Winston Churchill
On Oct 23, 2012, at 9:26 PM, "John Sherrer" <john@xxxxxxxxxxxxx> wrote:
> Hi Woodworkers
>
> I have an adaptive chess board from the blind folks in England. A couple of
> the pieces have pegs that are too short. The pegs have a diameter of about
> one eighth inch.
>
> Any ideas how to drill out the the pegs?
> John
>
> BlindWoodWorker.com
> Join our discussion list at:
> blindwoodworker-request@xxxxxxxxxxxxx
> with Subscribe in the subject.
>
Other related posts:
