6 Feb. 2014, 0:16 +01:00 mbielowicz wrote: >Let there be a workflow (without native calibration capabilities): Let it be! >1. Creating PrinterA calibration file (with printcal) >2. Creating PrinterA preliminary profile with calibration (from step 1) >applied to it. If you're not involving RIP calibration capabilities you should >apply the calibration curves onto the profiling target image. So use printarg >parameter which include the calibration AND apply it on target image. >3. Using PrinterA_preliminary.icm as targen -c parameter when creating main >profile. Yes. Just before that include the calbration into the profile by >applycal utility. Or check that the calibration was included in the profile >from *.ti3 file. I didn't remember how ArgyllCMS will do exactly, but the >calibration inside the preliminary profile is needed for targen to correct ink >limiting. >4. Next step is printtarg.... do I have to specify -K or -I parameter with >calibration file from step 1? The same as I've wrote for step two. Include and >apply calibration with printtarg.