[amayausers] Re: New roller installation help neede

Polymer goes on plastic to plastic or metal to plastic contact.  Multi purpose 
goes on metal to metal contacts.

Frank
Melco Authorized AMAYA tech and trainer


Original Message ----- 
  From: Beverly Thompson 
  To: amayausers@xxxxxxxxxxxxx 
  Sent: Monday, December 26, 2005 11:06 AM
  Subject: [amayausers] Re: New roller installation help neede


  I have been replacing some of the red pinch rollers,  and i thought they 
needed grease but i didn't know which grease.  I have two different kinds, one 
says grease multi-purpose and one says grease EMB Polymer.  which one?

  Regards,
  Beverly Thompson
  Perdido Beach Embroidery
    ----- Original Message ----- 
    From: Rod or Sharon 
    To: amayausers@xxxxxxxxxxxxx 
    Sent: Monday, December 26, 2005 9:17 AM
    Subject: [amayausers] Re: New roller installation help neede


      LuAnn,

      No that is not correct. Both sides of the hub need a small tab of grease 
as they are both contact bearing points.

      The red pinch rollers also need a small amount of grease applied to the 
inner bearing post that they rotate on as well.

      An IMPORTANT point to remember is NOT to allow ANY grease to come in 
contact with the surface of either roller. It has been found that any grease on 
either of these surfaces will result in the thread feeding off to the left side 
of the roller. If grease does get on these rollers, clean with soap and water, 
do not use any alcohol product.

      Hope you had a very nice Christmas and will have a Happy New Year.....

      Rod Springer

      Embroidery Cottage
      Rod & Sharon Springer
      Melco Amaya Tech & Trainer
      Design Shop Pro+ Digitizing

      Boise, ID  83713
      208-938-3038
        ----- Original Message ----- 
        From: image embriodery 
        To: amayausers@xxxxxxxxxxxxx 
        Sent: Monday, December 26, 2005 7:20 AM
        Subject: [amayausers] New roller installation help neede


        Good morning all,

        I hope everyone had a great holiday.
        Installing new rollers this morning and it would appear that only one 
side of the new thread feed roller gets grease on the hub. Is this correct?

        Thank you so much for your help!
        LuAnn @ Image Embroidery
        Because Your "Image" Matters

GIF image

Other related posts: