Beverly, The easy way to remember which grease goes where is to say "M" for metal (multi-purpose), and "P" for plastic (Polymer). Rod Springer Embroidery Cottage Rod & Sharon Springer Melco Amaya Tech & Trainer Design Shop Pro+ Digitizing Boise, ID 83713 208-938-3038 ----- Original Message ----- From: Beverly Thompson To: amayausers@xxxxxxxxxxxxx Sent: Monday, December 26, 2005 9:06 AM Subject: [amayausers] Re: New roller installation help neede I have been replacing some of the red pinch rollers, and i thought they needed grease but i didn't know which grease. I have two different kinds, one says grease multi-purpose and one says grease EMB Polymer. which one? Regards, Beverly Thompson Perdido Beach Embroidery ----- Original Message ----- From: Rod or Sharon To: amayausers@xxxxxxxxxxxxx Sent: Monday, December 26, 2005 9:17 AM Subject: [amayausers] Re: New roller installation help neede LuAnn, No that is not correct. Both sides of the hub need a small tab of grease as they are both contact bearing points. The red pinch rollers also need a small amount of grease applied to the inner bearing post that they rotate on as well. An IMPORTANT point to remember is NOT to allow ANY grease to come in contact with the surface of either roller. It has been found that any grease on either of these surfaces will result in the thread feeding off to the left side of the roller. If grease does get on these rollers, clean with soap and water, do not use any alcohol product. Hope you had a very nice Christmas and will have a Happy New Year..... Rod Springer Embroidery Cottage Rod & Sharon Springer Melco Amaya Tech & Trainer Design Shop Pro+ Digitizing Boise, ID 83713 208-938-3038 ----- Original Message ----- From: image embriodery To: amayausers@xxxxxxxxxxxxx Sent: Monday, December 26, 2005 7:20 AM Subject: [amayausers] New roller installation help neede Good morning all, I hope everyone had a great holiday. Installing new rollers this morning and it would appear that only one side of the new thread feed roller gets grease on the hub. Is this correct? Thank you so much for your help! LuAnn @ Image Embroidery Because Your "Image" Matters