[amayausers] Re: New roller installation help neede
- From: "Beverly Thompson" <beverlyt@xxxxxxxxxxx>
- To: <amayausers@xxxxxxxxxxxxx>
- Date: Mon, 26 Dec 2005 10:06:32 -0600
I have been replacing some of the red pinch rollers, and i thought they needed
grease but i didn't know which grease. I have two different kinds, one says
grease multi-purpose and one says grease EMB Polymer. which one?
Regards,
Beverly Thompson
Perdido Beach Embroidery
----- Original Message -----
From: Rod or Sharon
To: amayausers@xxxxxxxxxxxxx
Sent: Monday, December 26, 2005 9:17 AM
Subject: [amayausers] Re: New roller installation help neede
LuAnn,
No that is not correct. Both sides of the hub need a small tab of grease as
they are both contact bearing points.
The red pinch rollers also need a small amount of grease applied to the
inner bearing post that they rotate on as well.
An IMPORTANT point to remember is NOT to allow ANY grease to come in
contact with the surface of either roller. It has been found that any grease on
either of these surfaces will result in the thread feeding off to the left side
of the roller. If grease does get on these rollers, clean with soap and water,
do not use any alcohol product.
Hope you had a very nice Christmas and will have a Happy New Year.....
Rod Springer
Embroidery Cottage
Rod & Sharon Springer
Melco Amaya Tech & Trainer
Design Shop Pro+ Digitizing
Boise, ID 83713
208-938-3038
----- Original Message -----
From: image embriodery
To: amayausers@xxxxxxxxxxxxx
Sent: Monday, December 26, 2005 7:20 AM
Subject: [amayausers] New roller installation help neede
Good morning all,
I hope everyone had a great holiday.
Installing new rollers this morning and it would appear that only one
side of the new thread feed roller gets grease on the hub. Is this correct?
Thank you so much for your help!
LuAnn @ Image Embroidery
Because Your "Image" Matters
Other related posts: