Hello,
John has just posted in the Embroidery / How Do I? forum of AmayaUsers
Discussion Boards under the title of Hats.
This thread is located at
http://www.amayausers.com/discussion/showthread.php?6129-Hats
Here is the message that has just been posted:
***************
---Quote (Originally by ckramer)---
WSWHITING Put your design into Design Shop, flip it upside down, then
position the uppermost part of the design(¢er left to right) directly under
the horizontal red line which is your "origin" marker on your screen. Then
load it directly from DS to the machine. Mark your hat 1/2" up from the brim.
Now move your design using the hoop and arrow keys so that the red light shines
on that mark on hat. Now trace. Your design should now go as low as that mark
which is where you want it for placement above the brim. Only 1 1/2" tall
design should leave you more than enough room to maneuver in your frame.
---End Quote---
If they mark the hat .5 inches from the brim and then center on that using the
laser light, the design will be out of the hoop limits as it will use that as
the center point. Right?
Would be better to load the design in OS as you mentioned, then move using the
keypad while watching on screen till the design is just above the dotted line
hoop limits, then do a trace. Assuming you have the correct hoop selected in
the OS, it should show you exactly where the lowest point is.
***************
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================
