[amayausers.com] New Post/Thread Notification: Embroidery / How Do I?
- From: "AmayaUsers Discussion Boards" <theboards@xxxxxxxxxxxxxx>
- To: amayausers@xxxxxxxxxxxxx
- Date: Tue, 23 Jul 2013 16:22:10 +0000
Hello,
PSW has just posted in the Embroidery / How Do I? forum of AmayaUsers
Discussion Boards under the title of More Cap problems.
This thread is located at
http://www.amayausers.com/discussion/showthread.php?5533-More-Cap-problems
Here is the message that has just been posted:
***************
Hi Herb :D
This is amazing - it sewed perfectly. Thank you so much!
I have attached your comments to me because I think other newbies might benefit
from them. I am surprised that a supplied Melco font has a poor fill direction
built into it. Is this a problem just for caps or for other materials as well?
Did I just choose a poor font or should I be on the lookout for this with all
the fonts?
Thanks
Arlene
Try this version.
I changed some fill stitch direction as they were running at 90 and 270. We try
to stay away from angles that are 90/180/270 and 0. These will cause a fair
amount of pull in the design. Some of the underlay was excessive as well. The
lettering underlay was weak. I also bumped the pull comp up to give it room to
cover. My version has almost 1K stitches less than yours.
Structured or unstructured. Use the 270, hoop as shown in the video.
Structured, set your min thread feed to 8. Unstructured, set min thread feed to
6. Bobbin thread to just drop an inch or so when setting the tension.
If it is not hooped correctly, it will not sew...
***************
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================
Other related posts:
