Hello, Jaime has just posted in the Embroidery / How Do I? forum of AmayaUsers Discussion Boards under the title of Cap side troubles. This thread is located at http://www.amayausers.com/discussion/showthread.php?5542-Cap-side-troubles Here is the message that has just been posted: *************** I am using an Amaya XTS with a red WACF. I have a design that I have been trying over and over to get to come out right and it will not. The front lettering comes out fine, but the design on the side is horrible. I have now spent almost $100 with different digitizers who say the side design will work when they are done with it and it doesn't. I just keep getting thread breaks over and over again and it's very frustrating. I was using 75/11 ballpoint needles, then switched to 75/11 sharp. I have tried tightening the bobbin. I have tried different caps & different backing. I know it can be done because we used to order these same caps embroidered from a different company before they went out of business. The main reason we bought this machine was to do the embroidery for our advertising and everything has worked great except for these hats. I at least need to get 50 of these caps done and seem to be running out of options. Any ideas? What else can I try to make this work? I have only been doing this since December so I am still learning. *************** =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================