Mike Just a long shot but have you installed the little black sleeve over the screw type rod behind the needle case? It is supposed to stop the needle case from going too far to the right. I can't remember what the proper nomenclature is but Melco will know ab -----Original Message----- From: amayausers-bounce@xxxxxxxxxxxxx [mailto:amayausers-bounce@xxxxxxxxxxxxx] On Behalf Of Rnmkr2000@xxxxxxx Sent: Saturday, February 12, 2005 10:52 AM To: amayausers@xxxxxxxxxxxxx Subject: [amayausers] Machine won't find center? Whenever we go to load a design the machine instead of finding center goes all the way to the side and jams. Any ideas? We have tried re-starting and re-booting. Thanks for any advice, Mike & Bobbie VISIT OUR WEBSITE ! @ _campusemporium.com_ (http://www.campusemporium.com/) Campus Emporium Mike & Bobbie PH 540-552-1051 FX 540-552-2464