[amayausers.com] Re: Head timing problem

This message was posted by cbireley on AmayaUsers.com. PLEASE DO NOT REPLY VIA 
EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: 
http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/1/1030.html#000011

You know Rod, I don't know why I moved it.  I was just seeing if there were 
other issues. The needle isn't down, as in all the way to the bobbin area.  The 
needle is actually up, even w/others, the presser foot is directly behind the 
needle, but down so that it is even w/the bottom of the needle.  I know this is 
confusing and probably doesn't make much sense.  

The E Stop wouldn't shut off at first.  I turned the machine off, then back on 
and it then worked.

The needle bar does move up and down w/me turning the z-axis rod.

It is back at Needle 1

Hugo has serviced my machine, as well, so I can also touch base w/him. He has 
been very helpful in the past.  I have been lucky in that I've had no major 
troubles w/my machine in the 3-4 yrs. I've had it, so this may be the end of my 
"good luck"...hope not.

Thanks for your help and I'll keep you posted.  If Hugo cannot come visit me, 
yes, I may take you up on your offer b/c I'm in the middle of some major 
deadlines.

=========================================================== 

The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list

===========================================================

Other related posts: