From; "Gene" <Build_A_Computer@00> wrote: Click-N-Run (CNR) errors in LindowsOS: This tip is recommended for advanced users of LindowsOS. There are a few applications in the Click-N-Run Warehouse that require user interaction during their installation. Because of the automated process Click-N-Run uses, this leads to a partially configured application that can cause errors when subsequently trying to install other Click-N-Run applications. The symptoms of this are getting an error message that reads: "Sub-process /usr/bin/dpkg returned an error code (1)" and having an inordinate amount of subsequent failed Click-N-Runs. If you've experienced this, the following should produce better results until a long-term solution is in place: 1) Click on the "Launch" button (usually in the lower left-hand corner) 2) Select the "Run Command..." 3) Type in "Konsole" and select [Enter] 4) At the prompt type: apt-get -o Dir::Etc::sourcelist="/root/.los- apt-get/deps/apt/los-sources.list" -o Dir::State::lists=/root/.los- apt-get/deps/lists remove workman 5) Close Konsole by typing "exit" 6) Try Click-N-Run again. If you continue experiencing difficulties, please notify support at http://support.lindows.com.