I've been tasked with getting some network settings off a sample of machines across a statewide WAN. The machines are all win2k, set up with static IP addresses in an NT4 domain. There's about 30 that I have to get. The main thing I'm looking for is what the default gateway setting is for each box (I already have the IP addresses). This is on a client's network, so I don't really have access to every resource. Is there a command line method that I might be able to do this? I can't think of anything other than ipconfig, but I can't seem to find any switches that would allow for remote polling. or am I out of luck and will have to call each one of these users and walk them thru it? thanks! Brian Anderson Serapis Support Correctional Medical Service Office (314)919-9868 Pager (888)945-8643 Mobile (314)239-1398 banderson@xxxxxxxxxx http://www.serapisonline.com ******************************************************** This Week's Sponsor - RTO Software / TScale What's keeping you from getting more from your terminal servers? Did you know, in most cases, CPU Utilization IS NOT the single biggest constraint to scaling up?! Get this free white paper to understand the real constraints & how to overcome them. SAVE MONEY by scaling-up rather than buying more servers. http://www.rtosoft.com/Enter.asp?ID=147 ********************************************************** To Unsubscribe, set digest or vacation mode or view archives use the below link. http://thethin.net/win2000list.cfm