And I was just reading it and it describes how to change it after installation. Helps to Read the Fing manual, heh? _________________________________ Michael Boggan Network Engineer/Citrix Admin Virtual Desktop Inc. Dallas, Texas Ph: (972) 960-6400 Fax: (972) 960-6445 email: mboggan@xxxxxxxxxxx http://www.virtualdesktopinc.com <http://www.virtualdesktopinc.com> _________________________________ -----Original Message----- From: Jim Kenzig [mailto:jimkenz@xxxxxxxxxxxxxx] Sent: Tuesday, July 22, 2003 2:45 PM To: thin@xxxxxxxxxxxxx Subject: [THIN] Re: sql config Where may I ask did you read this? I suspect that you would only need to use tcp/ip if SQL server was on a different box than your datastore. Otherwise you should probably be ok. I don't think this setting can be change without reinstalling SQL server. JK -----Original Message----- From: thin-bounce@xxxxxxxxxxxxx [mailto:thin-bounce@xxxxxxxxxxxxx]On Behalf Of Michael Boggan Sent: Tuesday, July 22, 2003 2:59 PM To: 'THIN' Subject: [THIN] sql config Not knowing a lot about sql, I need to ask a question. I read that when setting up the connection to the data store you should use tcp/ip instead of named pipes which is the default. Is there a way to change this once it has been set? And if so, how? Thanks, _________________________________ Michael Boggan Network Engineer/Citrix Admin Virtual Desktop Inc. Dallas, Texas Ph: (972) 960-6400 Fax: (972) 960-6445 email: mboggan@xxxxxxxxxxx http://www.virtualdesktopinc.com <http://www.virtualdesktopinc.com> _________________________________