Actually I think that you have to upgrade to 5.5. I believe the reson is that e5.5 is the only version of Exchange (other than 2k) that uses LDAP and in order to import it to 2k you have to have LDAP running on the source and the target -----Original Message----- From: thin-bounce@xxxxxxxxxxxxx [mailto:thin-bounce@xxxxxxxxxxxxx] On Behalf Of Dave Sent: Sunday, December 22, 2002 3:46 PM To: THIN@xxxxxxxxxxxxx Subject: [THIN] Exchange 2000 Hi everyone - Happy holidays. Hopefully somebody has seen this problem before. We have an NT4 PDC server running Exchange 5.0 and we just put in a new W2K server with a different domain name running AD and am trying to run Exchange 2000 setup /forestprep to import from the oldserver and keep getting the following error: "Setup encountered an error while attempting to bind to the Exchange Server "Oldserver"; 0xC1010A91 (2705); An unknown error has occurred." I have created a trust between the two domains and gave the new domain admin full permissions to the Exchange 5.0 server and configuration properties. Any ideas of what I can try. Will this work - going from 5.0 to 2000 without going to 5.5 first? Thanks in advance Dave *********************************************** This Weeks Sponsor: 99point9.com The 99Point9.com Online Tech Support Helpdesk is the one-stop solution for all your server-based computing needs. http://www.99point9.com ************************************************ For Archives, to Unsubscribe, Subscribe or set Digest or Vacation mode use the below link. http://thethin.net/citrixlist.cfm *********************************************** This Weeks Sponsor: 99point9.com The 99Point9.com Online Tech Support Helpdesk is the one-stop solution for all your server-based computing needs. http://www.99point9.com ************************************************ For Archives, to Unsubscribe, Subscribe or set Digest or Vacation mode use the below link. http://thethin.net/citrixlist.cfm