John, Thanks for the information - can you give me any details on precisely = what needs to be changed? David -----Original Message----- From: Rowlandson, John [mailto:John.Rowlandson@xxxxxxxxxxxxx] Sent: Thursday, February 13, 2003 4:52 PM To: thin@xxxxxxxxxxxxx Subject: [THIN] Re: Cold Fusion Studio i have need to change some reg pers for non admins to use it john -----Original Message----- From: Rowswell, David [mailto:DRowswell@xxxxxxxxxxx] Sent: Friday, 14 February 2003 3:30 AM To: thin@xxxxxxxxxxxxx Subject: [THIN] Cold Fusion Studio Has anyone had any luck/experience/problems in installing Cold Fusion = =3D =3D3D Studio (the code editor, not the Cold Fusion engine) on Metaframe? Thanks in advance for any comments David ********************************************************* This Week's Sponsor - RTO Software / TScale TScale increases terminal server capacity.=20 Get 30-40% more users per server to save $$$ and time.=20 Add users now! - not more servers. If you're using Citrix,=20 you must learn about TScale! Free 30-day eval: http://www.rtosoft.com/Enter.asp?ID=3D79 ********************************************************** For Archives, to Unsubscribe, Subscribe or=20 set Digest or Vacation mode use the below link: http://thethin.net/citrixlist.cfm ********************************************************* This Week's Sponsor - RTO Software / TScale TScale increases terminal server capacity. Get 30-40% more users per server to save $$$ and time. Add users now! - not more servers. If you?re using Citrix, you must learn about TScale! Free 30-day eval: http://www.rtosoft.com/Enter.asp?ID=79 ********************************************************** For Archives, to Unsubscribe, Subscribe or set Digest or Vacation mode use the below link: http://thethin.net/citrixlist.cfm