Hi robert check the solder on this coil..Eric Pioneer SD-P50A3-K F105 4Amp opens intermittently Coil L107 looks O.K. measure low resistance , Re-solder very little solder or cracked joint hard to see. Eric E M Electronics Deer Lake Nfld Canada tvman@xxxxxxxxxxxxxxx Robert Father wrote: > Hi Techs, > This is a tough one. I am working on a Pioneer SDP50A3K Projection. > The set came in dead. I replaced fuse FU105 and soldered the entire board. > I also checked all caps and diodes. The set runs great until you shut the > system off. Once warmed up if you shut the set off it blows the fuse FU105. > Any help will be appreciated. Thanks in advance. > > Bob Father > Electronics Secialist > ALbany, New York > ----------------------------------------------------------------------------- > This Email List is Public. Remove: http://www.tech-assist.org/remove.htm > Lost Password: http://www.tech-assist.org and select "Login Problems?". > Appliance Repair List: http://www.tech-assist.org/secure/tip/chatjoin.htm#app > Email Archives: //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- This Email List is Public. Remove: http://www.tech-assist.org/remove.htm Lost Password: http://www.tech-assist.org and select "Login Problems?". Appliance Repair List: http://www.tech-assist.org/secure/tip/chatjoin.htm#app Email Archives: //www.freelists.org/archives/techassist/