As other has stated, bad connections on the yoke ( small pcb on each one ) will cause this.Even if you see V pulse at pin 7 of vert output ic ( most likely wrong waveshap). Been there done that!!.hth Country TV Ron Miller Inez, TX. 77968 ----- Original Message ----- From: "pete" <tvtech@xxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Thursday, May 12, 2005 8:47 PM Subject: [TechAssist] mitbishi projo vs45605 need help > Hi guys > The symptom is tv tries to start I hear high voltage then It shutsdown. > But I dont have to unplug to reset. I have checked the vertical section I > have vert pulse on pin 7 of vert Ic, output I have all the derived > voltages from the power supply before It shuts down, I have a good clean > waveform on the base of hot transistor. xray protect I have a normal > reading on pin 46 of Ic700 I disconnected the stks and replaced them I > have plus and minus voltages going to the stks, I also disconnected the > audio, I looked at the clock and data signal on pin 4 and 5 of tuner. What > else can I do?Any help will be greatly appreciated. > Perdomo Tv Inc Since 1972 > Miami.Fl > ----------------------------------------------------------------------------- > This Email List is Public. Remove: http://www.tech-assist.org/remove.htm > Lost Password: http://www.tech-assist.org and select "Login Problems?". > Appliance Repair List: > http://www.tech-assist.org/secure/tip/chatjoin.htm#app > Email Archives: //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- This Email List is Public. Remove: http://www.tech-assist.org/remove.htm Lost Password: http://www.tech-assist.org and select "Login Problems?". Appliance Repair List: http://www.tech-assist.org/secure/tip/chatjoin.htm#app Email Archives: //www.freelists.org/archives/techassist/