by the way,,,there is a jumper from the base of the HOT and the trace that goes to the driver transformer. It is right near the HOT. I've found many with this " loose connection" and now when I do any of these sets (ctc175-ctc187) I solder this as part of the general chassis solder which includes the tuner grnds, horz driver transformer etc. miglinasj wrote: >Check and see if pin 3 of u7401 is shorted to ground.(should be~15k). If >good, check voltages on pins 5+6 on the eeprom. See if they are low or >missing. On occasion I find the crystal loose on U3101. > Regards Jonas >----- Original Message ----- >From: "Thomas Woodward" <thomas.woodward@xxxxxxxxxxx> >To: <techassist@xxxxxxxxxxxxx>; "RepairWorld ListBot" ><listbot@xxxxxxxxxxxxxxx> >Sent: Thursday, February 07, 2002 9:40 AM >Subject: [TechAssist] ctc177af > > >>Hello everyone I have a ctc177af that is intermittent It will come on >>after I hit the board >>I have done all the soldering and the tuner fix . the unit ran ok for 1 >>hour then it was turned off now it will not start again >>Other than the epromm, any one have anything else they can think of >>Thanks for looking >>Tom >> >> >>-- >> >>Thomas S. Woodward A+,NET+, Crestron >>Master tech # 01965, >> >>Tri-Valley Repair >>32 Goshen Way >>Middleboro Ma. 02346 >>(508) 947-8119 >>(508) 359-7176 >>(617) 719-3958 (cell) >>mailto:thomas.woodward@xxxxxxxxxxx >>http://www.tri-ValleyRepair.cityslide.com/ >> >> >>------------------------------------------ >>Make your TechAssist database better! >>Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ >>------------------------------------------ >>To UNSUBSCRIBE your email address, click here: >>mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe >>Or send a BLANK email with unsubscribe in the >>SUBJECT field to the address above. >> > >------------------------------------------ >Make your TechAssist database better! >Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ >------------------------------------------ >To UNSUBSCRIBE your email address, click here: >mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe >Or send a BLANK email with unsubscribe in the >SUBJECT field to the address above. > > ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above.