If this set's HV Splitter is anything other than A-17196-12, it is probably bad, wiping out the flyback, HOT, and diode. All of these splitters have been upgraded to the A-17196-12. Normally replacing the Splitter, Flyback, HOT, and CRX3412 at the same time will solve the problem. Corey Brazell Audio Video Electronics 12169 SC hwy 121 Newberry Sc 29108 ----- Original Message ----- From: <Ttkirkpat@xxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Friday, August 30, 2002 9:08 PM Subject: [TechAssist] Zenith projection model Z60Z83D8 9-1674-01 module > > Set had shorted horizontal out, bad flyback and shorted crx3412 diode. > Replaced all with Zenith original- hooked up set and worked great for 35 > minutes. The horizontal output and crx3412 are shorted again. B+ voltages > were all perfect. Any helpers who could suggest why there might be a repeat > failure?? Thanks from Mike at the Video Center. My e-mail is ttkirkpat@xxxxxxx > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/