have a zenith projection tv Z5683R.....it came in with sound and no pic.....i changed the distribution block and the HV/SMPS board (9-1674-1).....when i turned the set on it fired then shutdown.....so i thought the new board was bad so i put in another board with the picture tubes and distribution block disconnected.....now the set does nothing.....all the stand-by voltages are there except the power DD voltage on the resistor (R4106) feeding transistor Q4103.....i assume that the set is in sutdown or PWR-FAIL.....there is supposed to be 29.0 VDC on the right end of the resistor, but there is only .7DC.....is it in PWR-FAIL?.....and if so what would cause that? ------------------- Don's TV Hut 1614 S. Combee Road Lakeland, FL 33801 863-668-9033 donstvrepair@xxxxxxx ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above.