Jeff, have you checked the 82K and the 100 k resisitors on the 1674? Glenn Larkman Audiotech 256 Nth Hwy 101 ENCINITAS CA 92024 760 944 9048 FAX 944 0345 mail to"mail@xxxxxxxxxxxxx" "www.audiotech.net" ----- Original Message ----- From: "Intrepid Video Support" <support@xxxxxxxxxxxxxxxxxx> To: "Techassist" <techassist@xxxxxxxxxxxxx> Sent: Wednesday, September 22, 2004 3:04 PM Subject: [TechAssist] Zenith Z52Z95DB 9-1690, 9-1674..height problems,., This set had bad convergence and no convergence correction. The 1 ohm resistors were smoked on the convergence panel. At the price of a 9-1690, I decided to replace the module. The first replacement, I had had for a while, so I ordered a new rebuilt. Thanks to Kevin Harris for sending me the schematic, I have my +/-26v to the convergence IC's and my 16vdc to the convergence s fine. I checked my v-h-pulses..they are OK. 5vdc on the 4 pin connector is right on.. I checked the pigtail fuses on main board. CR3419, I can not find..unless it sits on a heat sink near the fuse..Should I replace the convergence IC's on this new board..or could the problem still be on the 9-1674? Thank you. Jeff -- Intrepid Video TV/VCR Repair 263 S Front St, Steelton PA 17113 717-939-7708; (F) 717-564-4952 www.intrepid-video.com www.tech-repair.net ---------------------------------------------------------------------------- - Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/