Usually LX3201. The slug falls out or down and the coil overheats. ----- Original Message ----- From: "Phil Bader" <philbad@xxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Monday, September 16, 2002 11:37 AM Subject: [TechAssist] Zenith SG2799Y3 (split chassis design) pin cushion] > > > > > Zenith SG2799Y3, uses "split-chassis" design with a a 9-1075 > power/deflection board. > After replacing the fuse (storm damages) unit works, but has a noticable > side pincushion distortion.Not enough to pull in the sides severly, but > a bow. Probably the customer was living with this until the storm blew > the fuse. I assume the problem is on the 9-1075 smps/defl module, but > what? > Phil Bader > -- > Philip Bader > Jan Phyl TV Inc. (estab. 1976) > 3420 Recker Hwy. Winter Haven, Fl. 33880 > Fax (863) 299-8821 > email: philbad@xxxxxxxxxx > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ > ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/