On the power supply board near the IHVT behind it to the left is a resistor that is open, there is another just to the right of that resistor that needs to be changed also. I am at home so don't remember the values or location numbers but they are your fix. Shaun Advanced Electronics Fort Morgan, CO 80701 (970) 867-3124 satguy@xxxxxxxxxxxxx ----- Original Message ----- From: "C&W Electronics" <c_w_electronics@xxxxxxxxxxx> To: "Tech Assist" <techassist@xxxxxxxxxxxxx> Sent: Tuesday, June 17, 2003 7:36 PM Subject: [TechAssist] Zenith PVR5263 Projection - No convergence - > Convergence out of alignment, picture bowed. Changed Convergence module and Sweep module. Convergence still out, ICs have voltage, but are cold. > Paul W > C&W Electronics > Azle Texas > **************************************************************************** * > CHECK OUT THE NEW CHATROOM! Just login and click on chat! > http://www.tech-assist.org/secure/tip/main.htm > The Tech Address Book: > http://www.tech-assist.org/secure/tip/contact.htm > Add a Repair Tip Here, or Change/Remove your Email Address: > http://www.tech-assist.org/secure/tip/main.htm > Lost Password: > http://www.tech-assist.org and select "Lost your Login Info?". > Email Archives: > //www.freelists.org/archives/techassist/ ***************************************************************************** CHECK OUT THE NEW CHATROOM! Just login and click on chat! http://www.tech-assist.org/secure/tip/main.htm The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/