If you replaced the SMPS you may need to adjust your horiz & vertical adjustments on it located at the front of the PCB. MyTv OKC<OK Tvman99@xxxxxxx -----Original Message----- From: techassist-bounce@xxxxxxxxxxxxx [mailto:techassist-bounce@xxxxxxxxxxxxx] On Behalf Of al m Sent: Friday, October 04, 2002 10:37 AM To: techassist@xxxxxxxxxxxxx Subject: [TechAssist] Zenith PTV PVY4665DT sweep #9-1674-3 convergence # 9-1690 I know I saw this on here before but I can't find it in my records. I have this PTV that has just 3 bowed horizontal lines ,one of each color at the top of the screen .(horizontal as from side to side). The 1 ohm resistors on the convergence board are not open but they look hot. Is there any thing I can check on this board to see if the IC's are bad. al marquardt ampm@xxxxxxx ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/