Mando; Those 2 watt Resistors are very critical. I think they are 2.2 or 2.4 ohm. Measure them with a good meter. Preferably with one side pulled from circuit. -Ed- Tel-Tek Electronics Ontario-Canada teltek3@xxxxxxxxxxxx ----- Original Message ----- From: "armando guerra" <birdie@xxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Monday, March 08, 2004 11:36 AM Subject: [TechAssist] Toshiba Projo Model TZ43V61/ Convergence Problems > This set came in with bad convergence and pix curved at top and bottom > of screen. > This was last friday.I replaced both STK-392-110 and a 5amp fuse that > was open. > I left it running for the weekend and this morning it was off. I powered > it on and I can hear the high voltage come up and then shuts dn.I > removed the fuse that I replaced ( F840) and the pix comes on and stay's > on but of course with convergence way out.So,eighter I got a bad STK or > something else in that ckt is causing the failure.I don't have another > set of the stk's in stock and before I order them again,is there any > other part that I should check that may be causing the problem? The ic's > are in the power\convergence bd and its quite a job to remove the bd to > install this ic's so i want to make sure that I don't have to do this > again. If anyone has any tips or idea's on this model,would you please > let me know.Thanks. > Mando > Birdie's TV & Electronics > Casa Grande, AZ > PS Working without a sm. > > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/