Found Q801(STR52041) bad, Q802(2SA1020) shorted and some diodes bad. Replaced and now set fires up with no video or audio, HV is OK. Increase G2 to find retrace lines, but not very stable. B+ on REG seems to start at 160vdc and after it warms up a minute, increases up to 190vdc within a few seconds. I disconnected the yoke, thinking maybe it was shorted, same problem..then removed the CRT board, got a squeal from the chassis, but the B+ on the REG was the same reaction. Pin 1 of REG shows -40v, 3= -33.5vdc...and no, leads are not reversed. B+ to HOT measures a steady 135vdc. I have no schematic and was on Toshiba's site, but I guess they have nothing there for these older sets, though a 1996 unit. I've checked all diodes, ESR'd all caps and checked all resistors in the power supply and everything checks OK. Thank you. Jeff Dougherty Intrepid Video TV/VCR 263 S Front St Steelton PA 17113 fax...717-564-4952 www.intrepid-video.com www.tech-repair.net ***************************************************************************** Classifieds! Buy or Sell! http://sell.tech-assist.org The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/