Be certain that when you aligned the convergence that you didn't overscan the picture too large that the sensors are not picked up. I have made this mistake a couple times when not using a screen grid overlay. Just try moving the horizontal and vertical inward a bit Robert tvservice@xxxxxxxxxxxxx H & H Electronics Inc ----- Original Message ----- From: "John @ Myers TV" <myers_tv_b@xxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Wednesday, April 06, 2005 9:38 AM Subject: [TechAssist] Toshiba 578H83 ; Touch Fucus Error > Hi guys, > > I just changed the mvpu41B module on this one. While I was finishing up, I > tried the touch focus, and got a > "Touch Focus Error" > As part of the MVPU41B module kit, a new EEPROM is installed, and the TVOPT, > OPT1, & OPT2 need to be changed in the menu. > > The touch focus routine appears to run normally; It cycles through Hor & > Vert for all 3 colors, then gives the error message. > > I double checked that the screen sensors were plugged in, but beyond that > I'm stalled on this one. The set works normally otherwise. > > Anyone have any ideas? > > Thanks, > > > John Myers > Myers TV Service Company > 376 E. State St. > Alliance, OH 44601 > > phone: (voice & Fax) 330-821-6545 > myers_tv_b@xxxxxxxxxxxxx > www.myerstv.net > > -------------------------------------------------------------------------- --- > This Email List is Public. Remove: http://www.tech-assist.org/remove.htm > Lost Password: http://www.tech-assist.org and select "Login Problems?". > Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- This Email List is Public. Remove: http://www.tech-assist.org/remove.htm Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/