NTE2639 should be OK. But change D441 (9.1 volt zener) via R405 to pin 10 of the Flyback. Most Likely leaky causing Q404 to run too hot. -Ed- Tel-Tek Electronics Ontario-Canada teltek3@xxxxxxxxxxxx ----- Original Message ----- From: "armando guerra" <birdie@xxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Wednesday, April 07, 2004 3:02 PM Subject: [TechAssist] Toshiba 36" ctv model 36A41/chasis # TAC-0102 > This set is dead other than the relay latching on and the front led .The > hot is shorted and F470 is open. The hot has a part # of D2553 which > crosses over to a NTE-2639.I don't like using nte's unless no other > choice.Does anyone here have a better sub that I can use in a generic > form? Also,if there are some tips on this model for this 2 parts going > out,I would apreciate any and all tips and help.The flyback is ringing > ok.Maybe a bad yoke but I hope not since its a bonded type yoke. Thanks > for your help. > PS I tried logging into the Toshiba website but access denied.Its only > for ASC . > Mando > Birdie's TV & Electronics > Casa Grande, AZ > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/