Took unit a apart, to clean thoroughly. Removed and replaced all ribbon cables, cleaned film off LED's and she runs fine, now. Thanks for all the responses Jeff FAX 1-413-280-0677 Jeff Dougherty Intrepid Video & Electronics 501 Luther Rd Harrisburg, PA 17111 717-909-8844 VCR tips, electronics info & general interest. www.intrepid-video.com www.tech-repair.net www.thetoolcaddy.com ----- Original Message ----- From: "Jeff Dougherty" <jeff@xxxxxxxxxxxxxxxxxx> To: "Techsonline" <techassist@xxxxxxxxxxxxx> Sent: Tuesday, September 04, 2001 9:38 PM Subject: [TechAssist] Audio Fisher TAD993--CD problems > > This unit had a few problems with dust on lens and sensors. When I press > STOP, CD will pull from the lens, hesitate(I hear motor running) then be > pulled back to the CD Lens and pulled out again, sort of like VCR carriage > LED problem. > When I use the duster, it worked fine a few times. > I also had a problem with intermittent power to CD unit when I flexed the > board with the big transformer. Resoldered the board took care of that > problem. > Main problem now is no audio from the CD player. After the solder job, the > audio came back for a few seconds, then went out. This was the only time I > had audio from the CD player. If I press tuner or cassette, I get audio just > fine. > Whoa! I hope someone can help with this complex problem, as I do not do much > audio, but this is for a regular customer. Why did the audio work, right > after I did the solder job on the main transformer? > I would appreciate any comments. > Thank you. > > Jeff > > FAX 1-413-280-0677 > Jeff Dougherty > Intrepid Video & Electronics > 501 Luther Rd > Harrisburg, PA 17111 > 717-909-8844 > VCR tips, electronics info & general interest. > www.intrepid-video.com www.tech-repair.net www.thetoolcaddy.com > > > > Help make your TechAssist online repair tips > database better! Submit your fixes here: > http://www.circuitwork.com/techassist/tip/#tips > To unsubscribe write to: > techassist-request@xxxxxxxxxxxxx > with unsubscribe in the subject line. > Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips To unsubscribe write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line.