Fred, you didn`t say which caps you`ve replaced so I`m going to assume you missed one, look for a small red cap inside the open metal box ( if shield ) called C 301 or C 305, both of these caps MUST be changed, usually 2.2 @ 50v or 1uf @ 50v. I believe it`s 301 that is hidden in the if section and it is hard to find but it is part of the vert. problem, good luck, Larry E. American TV & Electronics fred krupalla wrote: >IV'E TRIED EVERYTHING I'M FAMILIAR WITH.SCOPE IS OUT.NEED TO SCOPE IT OUT.BUT >ALSO NEED TO CHECK DIODE.I WILL TRY TO FIND SCHEMATIC TOMORROW BUTN DOES >ANYONE HAVE ANY SUGGESTIONS. THANKS, >FRED >FRED'S TV >ADKINS,TX > > >------------------------------------------ >Make your TechAssist database better! >Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ >------------------------------------------ >To UNSUBSCRIBE your email address, click here: >mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe >Or send a BLANK email with unsubscribe in the >SUBJECT field to the address above. > > ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above.