Press power button, relay clicks on, power button-clicks off. When on, B+ slowly drops..no high voltage builds up. FBT reads ???? in circuit, OK out of circuit. 0.27 ohm resistor is OK as well as the stand-off resistors. B+ is 105vdc using the capacitor (-), but 18vdc using the FBT ground....is this normal? Found C2601 high ESR--had lower B+ before this. The board in area of R2603 is burnt. Printing on R2603 is worn off and measures 12ohms...so I assume this resistor is OK Any one run into this before? Jeff FAX 717-564-4952 Jeff Dougherty Intrepid Video & Electronics Be careful of your thoughts. 501 Luther Rd They may become your words Harrisburg, PA 17111 any moment. 717-909-8844 VCR tips, electronics info & general interest. www.intrepid-video.com www.tech-repair.net www.thetoolcaddy.com www.9-11-2001tragedy.com *********************************************************************** ------------------------------------------- Introducing NetZero Long Distance Unlimited Long Distance only $29.95/ month! Sign Up Today! www.netzerolongdistance.com ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/