Did you check for damper diodes on this IC? Is this the output IC connected to the Hi V Xfmr? Damon Brunger Telrad Electronics Fort Wayne IN ----- Original Message ----- From: "Dale Lubow" <harristv@xxxxxxxxx> To: "TechAssist" <techassist@xxxxxxxxxxxxx> Sent: Friday, May 27, 2005 11:40 PM Subject: [TechAssist] Sharp LCD Projector XG-E850U. IC1702 in ballast circuit shorts out when lamp starts > I am working on a Sharp LCD projector model XG-E850U. When the unit > came in the fans rand but the lamp wouldn't light. I found that pins > 2,3 & 9 of IC1702 were shorted. I replaced IC1702 and the unit ran > fine until it was shut off. Again the fans ran but the lamp wouldn't > light. I found IC1702 shorted the same way again. I am assuming IC1702 > works long enough to start the lamp but isn't needed to keep it > running. Has anyone had any similar problems with this unit? > > TIA, > Dale > --=20 > Dale A. Lubow CET > Harris TV & Appliance > 335 Lincoln Way > Ames, IA 50010 > 515-232-1109 (Voice) > 515-232-3356 (Fax) > HarrisTV@xxxxxxxxx > -------------------------------------------------------------------------- --- > This Email List is Public. Remove: http://www.tech-assist.org/remove.htm > Lost Password: http://www.tech-assist.org and select "Login Problems?". > Appliance Repair List: http://www.tech-assist.org/secure/tip/chatjoin.htm#app > Email Archives: //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- This Email List is Public. Remove: http://www.tech-assist.org/remove.htm Lost Password: http://www.tech-assist.org and select "Login Problems?". Appliance Repair List: http://www.tech-assist.org/secure/tip/chatjoin.htm#app Email Archives: //www.freelists.org/archives/techassist/