Lots of tips!!!!!!!!!!!!!! --------------------------------------------------------------- Text pasted from WinSTIPS 2.0 http://www.ServiceSoftware.com --------------------------------------------------------------- TOSHIBA TZ43V61 Clock Runs Fast Jerry - Vision Video Labs, Inc The Clock Gains Approx 15 Min Every Hour. Add A 0.01 Uf Cap From Pin 10 Of Qa01 To Isolated Ground As Near Pin 10 As Possible. --------------------------------------------------------------- TOSHIBA TZ43V61 On Screen Display No Go Defective QR01 (OSD IC) --------------------------------------------------------------- TOSHIBA TZ43V61 Picture No Go / OSD OK / No Sound / Bad Convergence Daniel Mundy, CET®/CSM Go into service mode and do an E2 reset. Press and hold the RECALL button on the Remote, then press the CHANNEL button on the TV. The initialization of QA02 has been completed. You should also know that doing this reset may require setting the B&W tracking and geometry adjustments. I don't like doing it, but if the EEPROM data has been glitched that is the cure --------------------------------------------------------------- TOSHIBA TZ43V61 <Service Menu> Press and release mute on remote Press and hold mute on remote and press menu on TV. Press menu on TV. ------------------------------------------------------------------------------------------------------------------------------ Text pasted from WinSTIPS 2.0 http://www.ServiceSoftware.com --------------------------------------------------------------- TOSHIBA TZ50V61 Color / No Or Intermittent Color Phil Hull Found Bad Solder Connection At X501 On The Vcd Board. . --------------------------------------------------------------- TOSHIBA TZ50V61 Convergence - Pix Distorted - Conv, Vert, Pin. Simpson'S Tv Bad Divider=Tpa5007 Part # --------------------------------------------------------------- TOSHIBA TZ50V61 High Voltage No Go - Has 125v At Collector Of Hot TV Doctor - Thousand Oaks California Bad D430 On A Board Does Check Good, But Supplys Horz --------------------------------------------------------------- TOSHIBA TZ50V61 Led Blinking At .5 Second Rate. Dead Set. Not Shutdown. Toshiba C840 Replaced C840 On Reset Line. --------------------------------------------------------------- TOSHIBA TZ50V61 Light Box Design This Unit Has A Removable Light Box Design --------------------------------------------------------------- TOSHIBA TZ50V61 Picture Is Too Wide By About An Inch On Either Side. Cannot Adjust Toshiba Yoke Found Bad Blue Deflection Yoke Yoke Runs Warm After Playing A While. --------------------------------------------------------------- TOSHIBA TZ50V61 Picture Lacks Green Bob Waterman, Cet Gemini Computer & Tv Replaced Leaky Diodes (Ref# D911, D912 - Part# A7150258) On G-Drive Pcb --------------------------------------------------------------- TOSHIBA TZ50V61 Shut Down Dennis Newman The Fix Turned Out To Be A Shorted Blue Yoke. Even Though I Tried Unplugging It Earlier. Also This Yoke Had Evidently Gotten So Hot It Cracked Or Glazed The Neck Of The Tube And It Broke With A Touch When I Tried To Remove The Yoke. --------------------------------------------------------------- TOSHIBA TZ50V61 Shutdown Caused By Excessive Video Toshiba Q501 Low Abl Voltage. Abl Voltage Went To Normal Level With Abl Pin Desoldered Abl & Rgb Out At Q501 --------------------------------------------------------------- --------------------------------------------------------------- Text pasted from WinSTIPS 2.0 http://www.ServiceSoftware.com --------------------------------------------------------------- TOSHIBA TZ55V61 Osd Goes Fuzzy Gateway Electronics Inc. Frank D'Alio Replace Qr01 With Part # 23906910, Check First Pin 22 & 27 Vdd 5volts Pin 5 Reset For 5volts, Pin 12 Horiz Sync 4 To 5 Vpp, Pin 13 Vert Sync 4 To 5 Vpp. --------------------------------------------------------------- TOSHIBA TZ55V61 OSD No Go Qv01 On Vcd Board --------------------------------------------------------------- ========================== Jeff Stielau Shoreline Electronics Repair 344 East Main Street Clinton,CT 06413 860-399-1861 860-664-3535 (fax) jstielau@xxxxxxxx ======================== ----- Original Message ----- From: "Dieu Huynh" <ptg_ltd@xxxxxxxx> To: "tech assist" <techassist@xxxxxxxxxxxxx> Sent: Saturday, February 19, 2005 10:24 AM Subject: [TechAssist] Service info Toshiba TZ43V61 > Hello all > anyone have info on this toshiba projo can share thankyou, > Danny Huynh > ptg electronics ltd > winnipeg manitoba > 204 831 0862 > > > > --------------------------------- > Post your free ad now! Yahoo! Canada Personals > > > > ----------------------------------------------------------------------------- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/