Hello Ed, I agree with peter. I will replace the whole cable, as I would not want to go to the trouble of replacing the end and find I still have an intermattant in the cable. Also, on another note, Peter, I think your sig file is going at the very bottem. When you reply, you should see what your sending in the editor before being sent. (Your sig file) Thanx, Scott Beebe Ohm Electronics Inc. 609 W. Clinton St. Ithaca NY 14850 Voice: (607) 273-8406 Fax: (607) 273-8743 WWW.OhmElectronicsInc.com mailto:Scott@xxxxxxxxxxxxxxxxxxxxx Thursday, April 8, 2004, 10:00:10 AM, you wrote: > Hi Ed -This is a real pain.I do a lot of > monitors and since the DB15 plug is molded,the cord must be > replaced.I'll look in my junk if you can show or tell me > what's on the monitor end of the cable...........Regards, > Pete > Ed Gaidies <teltek3@xxxxxxxxxxxx> wrote: > Need some advice guys. > Customer brought in a Samsung Monitor that was > not getting any input from > the Video Card. I see a Pin is missing from the > plug. (broken off). What's > the easiest and cheapest way to repair these > molded plugs. Or is it better > to try to get a new Wiring Harness, if > available. There are just 2 sets of > plugs coming out at the Monitor End. > Thanks. > -Ed- > Tel-Tek Electronics > Ontario-Canada > teltek3@xxxxxxxxxxxx > ----------------------------------------------------------------------------- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > Peter Neal > Neal Electronics > 1905 E. Wm.Cannon > Austin,TX 78756 > ----------------------------------------------------------------------------- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/